1. Dishwashing detergent and warm water poured into a plastic basin to dissolve.
2. the copper tube into the basin (if too long no clear, you can soak for a few hours, so that some of the impurities inside the softening, convenient and better cleaning), with a bent pipe through the bar brush scrubbing tube several times, the sewage poured out, pouring water into the water, and then repeat the action, until cleaned.
3. cut gauze into the appropriate size (do not be too big, so as not to get stuck in the tube, such as not sure to cut a little smaller) installed in the through the bar (remember that this is not the use of the elbow through the bar brush), clean the inside of the copper pipe and to be loaded into the copper pipe part of the inner tube, through a few times on the replacement of the new gauze until the gauze no longer have the dirt.
4. Repeat the third action, but this time to pass before some medicinal alcohol (remember never use industrial), also to pass several times, in addition to the possibility of removing some of the dirt, the most important thing is to disinfect, don’t forget that there is originally on the part of the copper pipe oil should also be wiped clean.
5. The last thing to do is to reapply the new copper pipe grease, remember to apply only half of the pipe, the pipe will naturally be slowly squeezed to the back half after loading, if not enough then apply again, so as not to squeeze out a lot after loading the whole pipe, resulting in unnecessary waste.
